how to fix vape cartridge wire

Views: 112 Author: Site Editor Publish Time: Origin: Site

Vaping has become increasingly popular over the years, and one of the key components of a vape device is the cartridge. This small, refillable container holds the e-liquid and is screwed onto the battery-powered vape pen or mod. However, one common issue that vapers may encounter is a broken wire in the vape cartridge. In this article, we will discuss how to fix vape cartridge wire.

Step 1: Identify the Problem

Before attempting to fix the vape cartridge wire, it is important to identify the problem. If there is a broken or disconnected wire, the coil will not heat up properly, and there will be no vapor production. You may also notice a burnt taste when using the vape pen. Once you have identified the problem, you can proceed with the repair.

Step 2: Gather the Necessary Tools

To fix the vape cartridge wire, you will need a few basic tools, including a pair of tweezers, a small screwdriver or needle-nose pliers, and a replacement wire. You can purchase a replacement wire at your local vape shop or online.

Step 3: Remove the Old Wire

To remove the old wire, use the tweezers to gently pull out the cotton wick from the cartridge. Then, use the screwdriver or needle-nose pliers to unscrew the two screws that hold the wire in place. Carefully remove the wire from the cartridge and dispose of it properly.

Step 4: Install the New Wire

Take the replacement wire and insert one end into the small hole next to the screw on the positive side of the cartridge. Use the screwdriver or needle-nose pliers to tighten the screw and secure the wire in place. Make sure the wire is tight and secure, but not too tight that it breaks. Repeat this process for the negative side of the cartridge.

Step 5: Test the Vape Cartridge

After installing the new wire, it is important to test the vape cartridge before using it. Reinsert the cotton wick and fill the cartridge with e-liquid. Screw the cartridge back onto the vape pen or mod and turn it on. Allow the vape pen to heat up for a few seconds before taking a puff. If there is vapor production and no burnt taste, then the vape cartridge wire has been successfully fixed.

Conclusion

A broken wire in a vape cartridge can be frustrating, but it can be easily fixed with the right tools and a little patience. By following the steps outlined in this article, you can repair your vape cartridge wire and get back to enjoying your favorite e-liquid flavors. Remember to always handle vape devices with care and dispose of broken or damaged components properly.

×

Contact Us

captcha